Image Fitness Renew 400 Canadian English Manual - Page 8

Assembly Before beginning assembly, carefully read the following information and instructions: • Place all parts in a cleared area and remove the packing materials from the spa shell. Do not dispose of the packing materials until assembly is completed and the spa is in operation. • During assembly, make sure that all parts are oriented as shown in the drawings. • Read each assembly step before you begin. • Tighten all parts as you assemble them, unless instructed to do otherwise. ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included): • One (1) phillips screwdriver • You may also need soap or water. 1. Before beginning assembly, make sure that you 1 have read and understand the information in the box above and on the previous two pages. 2 Remove the four #6 x 1 1/4" Wood Screws (7) from the Access Cover (2). Remove the Access Cover from the spa by sliding the Access Cover down and pulling the bottom of it away from the spa. Make sure that you don't damage the spa shell. 7 2. Close the valve knob on the drain hose. Thread the cap onto the drain hose. Thread the Drain Plug 2 into the Pump Motor. Tighten the pump fittings. Re-attach the Access Cover (2) with the four #6 x 1 1/4" Wood Screws (7) removed in step 1. 7 Pump Motor Drain Plug Cap Valve Knob Pump Fittings Drain Hose 3. The hydrotherapy spa is designed to operate with a 120 volt power source and must be wired directly to a 120 volt ground fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a licensed, qualified electrician and conform with all local, state, and national electrical codes. Before you have the spa wired, be sure that it is in the position you want, and that it can easily be serviced, if needed. 8