InSinkErator Model Hot1 Owners Manual - Page 9

5 FILL THE TANK & CONNECT POWER A I First, open the shutoff valve all the way and see if your connections are watertight. If there are any leaks carefully re-tighten all connections. Property Damage: Never place a restriction on the delivery of water from the spout. Such a restriction prevents draining the expansion chamber and could damage the tank. B Valve Lever I Press valve lever down for about 20 seconds until water freely runs out of the spout. Hold valve open at least 60 seconds to let the water run to flush out the lines. I Water will be cold since tank has not been plugged in yet. Property Damage: Do not connect electric power until tank is filled with water. Failure to do so may damage heating element or thermal safety fuse and will void the warranty. C Property Damage: Do not remove or alter the thermal safety fuse. If you suspect the thermal fuse is open, contact your Authorized Service Center. I Check all connections to ensure they are tight and that there are no leaks, then plug in instant hot water tank. I Allow 10-15 minutes for water to reach target temperature. Gurgling or hissing is normal during the initial heating cycle. Steam and/or hot water coming from the spout without pressing down on the handle is also normal. If steam is still emitted after setup, thermostat adjustments may be needed (pg. 11). 9