Intel BLKDQ35JOE Product Specification - Page 21
Serial ATA Interfaces
UPC - 200001401862
View all Intel BLKDQ35JOE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Product Description 1.6.1.5 Advanced Digital Display (ADD2/MEC) Card Support The GMCH routes two multiplexed SDVO ports that are each capable of driving up to a 225 MHz pixel clock to the PCI Express x16 connector. When an ADD2/MEC card is detected, the Intel GMA 3100 graphics controller is enabled and the PCI Express x16 connector is configured for SDVO mode. SDVO mode enables the SDVO ports to be accessed by the ADD2/MEC card. An ADD2/MEC card can either be configured to support simultaneous display or can be configured to support dual independent display as an extended desktop configuration with different color depths and resolutions. ADD2/MEC cards can be designed to support the following configurations: • Low Voltage Differential Signaling (LVDS) • Single device operating in dual channel mode • HDTV output • HDMI support (when used with the HD Audio Link) 1.6.2 USB The board supports up to 12 USB 2.0 ports, supports UHCI and EHCI, and uses UHCIand EHCI-compatible drivers. The ICH9DO provides the USB controller for all ports. The port arrangement is as follows: • Six ports are implemented with stacked back panel connectors • Six ports are routed to three separate front panel USB headers For information about The location of the USB connectors on the back panel The location of the front panel USB headers Refer to Figure 10, page 44 Figure 11, page 45 1.6.3 Serial ATA Interfaces The board provides five Serial ATA (SATA) connectors, which support one device per connector. The board also provides one red-colored external Serial ATA (eSATA) connector. 1.6.3.1 Serial ATA Support The ICH9DO I/O controller offers six independent Serial ATA ports with a theoretical maximum transfer rate of 3 Gbits/sec per port. One device can be installed on each port for a maximum of six Serial ATA devices. A point-to-point interface is used for host to device connections, unlike Parallel ATA IDE which supports a master/slave configuration and two devices per channel. For compatibility, the underlying Serial ATA functionality is transparent to the operating system. The Serial ATA controller can operate in both legacy and native modes. In legacy mode, standard IDE I/O and IRQ resources are assigned (IRQ 14 and 15). In Native mode, standard PCI Conventional bus resource steering is used. Native mode is the preferred mode for configurations using the Windows* XP and Windows Vista* operating systems. 21