Intel X5472 Specification Update - Page 20

buffer. The information in the PEBS record represents the state of the next instruction to be executed following the counter overflow. Due to this erratum, if the counter overflow occurs after execution of either MOV SS or STI, storage of the PEBS record is delayed by one instruction. Implication: When this erratum occurs, software may observe storage of the PEBS record being delayed by one instruction following execution of MOV SS or STI. The state information in the PEBS record will also reflect the one instruction delay. Workaround: None identified. Status: For the steppings affected, see the Summary Tables of Changes. AX8. Performance Monitoring Event FP_MMX_TRANS_TO_MMX May Not Count Some Transitions Problem: Performance Monitor Event FP_MMX_TRANS_TO_MMX (Event CCH, Umask 01H) counts transitions from x87 Floating Point (FP) to MMX™ instructions. Due to this erratum, if only a small number of MMX instructions (including EMMS) are executed immediately after the last FP instruction, a FP to MMX transition may not be counted. Implication: The count value for Performance Monitoring Event FP_MMX_TRANS_TO_MMX may be lower than expected. The degree of undercounting is dependent on the occurrences of the erratum condition while the counter is active. Intel has not observed this erratum with any commercially available software. Workaround: None identified. Status: For the steppings affected, see the Summary Tables of Changes. AX9. A REP STOS/MOVS to a MONITOR/MWAIT Address Range May Prevent Triggering of the Monitoring Hardware Problem: The MONITOR instruction is used to arm the address monitoring hardware for the subsequent MWAIT instruction. The hardware is triggered on subsequent memory store operations to the monitored address range. Due to this erratum, REP STOS/MOVS fast string operations to the monitored address range may prevent the actual triggering store to be propagated to the monitoring hardware. Implication: A logical processor executing an MWAIT instruction may not immediately continue program execution if a REP STOS/MOVS targets the monitored address range. Workaround: Software can avoid this erratum by not using REP STOS/MOVS store operations within the monitored address range. Status: For the steppings affected, see the Summary Tables of Changes. AX10. Performance Monitoring Event MISALIGN_MEM_REF May Over Count Problem: Performance monitoring event MISALIGN_MEM_REF (05H) is used to count the number of memory accesses that cross an 8-byte boundary and are blocked until retirement. Due to this erratum, the performance monitoring event MISALIGN_MEM_REF also counts other memory accesses. Implication: The performance monitoring event MISALIGN_MEM_REF may over count. The extent of the over counting depends on the number of memory accesses retiring while the counter is active. Workaround: None identified. Status: For the steppings affected, see the Summary Tables of Changes. Intel® Xeon® Processor 5400 Series 20 Specification Update