Invacare 4V66FLR Owners Manual - Page 32

Removing/Installing the Rear Wheels

Get Invacare 4V66FLR PDF manuals and user guides View all Invacare 4V66FLR manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

B D A C 5.7 Removing/Installing the Rear Wheels WARNING! - Only a qualified technician may change the size of the rear wheel or the seat-to-floor height. - If changing the size of the rear wheel or a change in the seat-to-floor height is desired, this procedure must be performed by a qualified technician. - Make sure both rear wheels are the same size and are installed into the same respective mounting hole before using the wheelchair, otherwise injury may occur. - This procedure MUST be performed by a qualified technician. If replacing the same size rear wheel, note the mounting position on the wheelchair frame for proper reinstallation of the new rear wheel. Service 1. Remove the dust cap A, hex screw B, washer C, spacer (if installed) D and locknut E that secure the rear wheel F to the wheelchair frame G. The spacer is used on wheelchairs with removable arms only. 2. Repeat STEP 1 for the opposite rear wheel if desired. 3. To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS 1-2 and torque locknut to 40 ft.-lbs. 4. Adjust wheel locks. 5.14 Adjusting the Patient Operated Wheel Locks, page 35. D C B A G E F 1567855-C 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
Service
5.7
Removing/Installing the Rear Wheels
WARNING!
–
Only a qualified technician may change the size of the
rear wheel or the seat-to-floor height.
–
If changing the size of the rear wheel or a change in
the seat-to-floor height is desired, this procedure
must be performed by a qualified technician.
–
Make sure both rear wheels are the same size and
are installed into the same respective mounting hole
before using the wheelchair, otherwise injury may
occur.
–
This procedure MUST be performed by a qualified
technician.
If replacing the same size rear wheel, note the mounting
position on the wheelchair frame for proper reinstallation
of the new rear wheel.
1.
Remove the dust cap
A
, hex screw
B
, washer
C
, spacer (if
installed)
D
and locknut
E
that secure the rear wheel
F
to
the wheelchair frame
G
.
The spacer is used on wheelchairs with removable arms
only.
2.
Repeat STEP 1 for the opposite rear wheel if desired.
3.
To reinstall the rear wheel(s) onto the wheelchair, reverse
STEPS 1-2 and torque locknut to 40 ft.-lbs.
4.
Adjust wheel locks. 5.14 Adjusting the Patient Operated Wheel
Locks, page 35.
1567855-C
31