JVC CW-DRA8 Operation Manual - Page 7
Operation, Fuse exchange
View all JVC CW-DRA8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Installing the remote control unit Install the remote control unit on the vehicle by the provided hook-and-loop fastener. ᶃRemote control (Rear panel) Vehicle ᶋ Hook-and-loop fastener (Harder surface) ᶋ Hook-and-loop fastener (Softer surface) Fuse exchange Caution: Install the remote control unit in a position that does not come in the way of driving operations. Avoid installing it in a place subject to direct sunlight or direct hot wind from the heater. Otherwise, the product may be degraded and a fire hazard may result. Remove dirt from the installation position before attaching the hook-and-loop fastener. Exchange with the specified capacity fuse. Caution: Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 10A. Removal Fuse Cover Fuse holder ⁞ Open the cover. Grasp the fuse and pull up. Operation Insertion Replacement fuse 10 A ⁞ Insert the fuse gently into the fuse holder and push in all the way with your finger. Close the cover. Name of each part (Remote control ) Illumination When the power turns ON, the illumination lights. VOLUME control knob (Input sensitivity control knob) FREQUENCY control knob (Cut-off frequency control knob) PHASE switch (Phase select switch) Note: Large power input will cause the protection circuit for this unit to operate, which will decrease output level. In this case, turn the volume to "MIN" for a while, then eventually this unit will automatically start working again. The sound is output even when the remote control unit is not connected, but the operations described in this section are not available. In this case, the volume, cut-off frequency and phase are set to the predetermined default conditions, with which the cut-off frequency is 125 Hz and the phase is 0° (positive). Adjusting the sound (Remote control operation) ⁞ Turn the FREQUENCY control knob to adjust the cut-off frequency (frequencies higher than this frequency are cut off). Turn the FREQUENCY control knob to adjust the balance between the bass from the rear speakers and the bass from this unit as desired. 50 Hz 125 Hz Sound pressure level Low High Low High Frequency Adjust the low frequency phase. The low frequency tone may be variable depending on the position of the unit, its orientation or the turn-over frequency. This can be adjusted by changing the position of the PHASE switch. Set this switch to either position according to your liking. [0°] indicates the normal phase and [180°] means the reverse phase. Turn the VOLUME control knob to adjust the low frequencies to the desired level. To decrease volume To increase volume 7 English