JVC GR-AXM18US Instructions - Page 7
ATTENTION, REFRESH, Charging the Battery Pack, Using the Battery Pack, Using AC Power - power adapter
UPC - 046838024108
View all JVC GR-AXM18US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
GETTING STARTED GETTING STARTED Hook on BATTERY RELEASE Switch Battery pack Push in Power Switch To AC outlet AC Adapter To DC IN connector Charging the Battery Pack 1) Hook the end of the battery pack to the camcorder and push the battery in until it locks in place. • If the battery pack is attached wrongly, a malfunction may occur. 2) Set the Power Switch # to "OFF" while pressing down the Lock Button ". Connect the AC Adapter to the DC IN connector 9, then plug the AC Adapter to the AC Outlet. 3) The CHARGE lamp $ blinks to indicate charging. 4) When the CHARGE lamp $ stops blinking and turns off, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder. To Detach The Battery Pack... ... slide BATTERY RELEASE 8 and pull out the battery pack. Battery Pack BN-V10U BN-V12U (optional) BN-V20U (optional) BN-V400U (optional) Charging time approx. 1 hr. 30 min. approx. 1 hr. 40 min. approx. 2 hrs. 40 min. approx. 5 hrs. 10 min. Charging time is for a fully discharged battery pack. Using the Battery Pack Perform step 1) of "Charging the Battery Pack". Approximate recording time (unit: min.) Battery Pack Viewfinder on LCD monitor on BN-V10U 100 80 BN-V12U 105 85 (optional) BN-V20U 170 140 (optional) BN-V400U 400 330 (optional) Using AC Power Connect the AC Adapter to the camcorder (੬ step 2) of "Charging the Battery Pack"). • The provided AC Adapter features automatic voltage selection in the AC range from 110V to 240V. ATTENTION: Before detaching the power source, make sure that the camcorder's power is turned off. Failure to do so can cause the camcorder to malfunction. REFRESH: Be sure to fully discharge a battery pack before recharging or storing it for a long period of time, otherwise the battery performance will be reduced. 1) Perform steps 1) through 3) of "Charging the Battery Pack". 2) Press REFRESH ! for over 4 seconds. The CHARGE lamp $ blinks faster to indicate discharging. 3) When discharging is finished, charging automatically starts and the CHARGE lamp $ blinks normally. 7