JVC HR-XVC33U Instruction Manual - Page 86
Timer Recording Vcr Deck - troubleshooting
View all JVC HR-XVC33U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
86 EN TROUBLESHOOTING (cont.) TIMER RECORDING (VCR deck) SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION 1. Timer recording won't work. ● The clock and/or the timer have been set incorrectly. Re-perform the clock and/or timer settings. ● The timer is not engaged. Press TIMER and confirm that "#" is displayed on the front display panel. 2. Timer programing is not possible. ● Timer recording is in progress. Timer programing can't be performed while a timer recording is in progress. Wait until it finishes. 3. "#" on the front display panel won't stop blinking. 4 and "$" on the front display panel won't stop blinking. ● The timer is engaged but there's no cassette loaded. ● The loaded cassette has had its record safety tab removed. Load a cassette with the record safety tab intact. Remove the cassette and cover the hole with adhesive tape, or insert a cassette with the record safety tab intact. ● The end of the tape was reached during timer recording. The program may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire program. 5. "#" blinks for 10 seconds and the Timer mode is disengaged. 6. "⅜" and "$" on the front display panel won't stop blinking. 7. "N", "⅜" and "$" on the front display panel won't stop blinking. ● TIMER has been pressed when there are no programs in memory, or the timer record information has been programed incorrectly. ● The end of the tape was reached during Instant Timer Recording. ● The loaded cassette has had its record safety tab removed. Check the programed data and reprogram as necessary, then press TIMER again. The program may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire program. Remove the cassette and cover the hole with adhesive tape, or insert a cassette with the record safety tab intact. ● The end of the tape was reached during Satellite Auto Recording. The program may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire program.