JVC KD-X230 Instruction Manual - Page 15

TROUBLESHOOTING Symptom Remedy Sound cannot be heard. • Adjust the volume to the optimum level. • Check the cords and connections. General "MISWIRING CHECK WIRING THEN PWR ON" appears. Turn the power off, then check to be sure the terminals of the speaker wires are insulated properly. Turn the power on again. "PROTECTING SEND SERVICE" appears. Send the unit to the nearest service center. Source cannot be selected. Check the [SRC SELECT] setting. ( 4) Radio • Radio reception is poor. • Static noise while listening to the radio. Connect the antenna firmly. Playback order is not as intended. The playback order is determined by the file name. Elapsed playing time is not correct. This depends on the recording process earlier. "NOT SUPPORT" appears and Check whether the file is a playable format. ( 11) file skips. USB / iPod "READING" keeps flashing. • Do not use too many hierarchical levels and folders. • Reattach the USB device. "CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with this or connected device cannot unit and ensure the files are in supported formats. ( 11) be detected. • Reattach the device. The iPod/iPhone does not • Check the connection between this unit and iPod/iPhone. turn on or does not work. • Detach and reset the iPod/iPhone using hard reset. Correct characters are not displayed. • This unit can only display uppercase letters, numbers, and a limited number of symbols. • Depending on the display language you have selected ( 4), some characters may not be displayed correctly. Symptom Remedy • Sound cannot be heard during playback. • Sound output only from the Android device. • Reconnect the Android device. • If in [AUDIO MODE], launch any media player application on the Android device and start playback. • If in [AUDIO MODE], relaunch the current media player application or use another media player application. • Restart the Android device. • If this does not solve the problem, the connected Android device is unable to route the audio signal to unit. ( 12) ANDROID Cannot playback at [AUTO MODE]. • Make sure JVC MUSIC PLAY APP is installed on the Android device. ( 7) • Reconnect the Android device and select the appropriate control mode. ( 8) • If this does not solve the problem, the connected Android device does not support [AUTO MODE]. ( 12) "NO DEVICE" or "READING" keeps flashing. • Switch off the developer options on the Android device. • Reconnect the Android device. • If this does not solve the problem, the connected Android device does not support [AUTO MODE]. ( 12) Playback is intermittent Turn off the power saving mode on the Android device. or sound skips. "CANNOT PLAY" • Make sure Android device contains playable audio files. • Reconnect the Android device. • Restart the Android device. If you still have troubles, reset the unit. ( 3) ENGLISH 13