JVC LT-32D200 Instructions - Page 11

INTRODUCTION PREPARATION WATCHING TV OPTIONAL SETTING OPERATING DVD DVD SETTING TROUBLESHOOTING INFORMATION English No supplied cables are used in this connection: Please purchase the necessary cables at your local store. High Speed HDMI cable (also known as HDMI category 2 cable) is recommended for the better compatibility. 5 External Device Connection [HDMI Connection] HDMI connection offers the highest picture quality. HDMI (High-Definition Multimedia Interface) transports high definition video and multi-channel digital audio through a single cable. HDMI CEC (Consumer Electronics Control) allows the TV to connect and control multiple HDMI CEC enabled devices with a single remote. CEC (Consumer Electronics Control) is an optional protocol used in HDMI. HDMI CEC on this TV is compliant with "High-Definition Multimedia Interface Specification". The TV does not support HDMI CEC functions that are not listed below. The TV does not guarantee to support use of all HDMI CEC enabled devices. Devices that are not enabled to HDMI CEC cannot be controlled with this TV. Control the TV using the HDMI CEC enabled device Turn the TV on and switch to the video source of the operating device. Switch to the video source of the operating device. Control the HDMI CEC enabled device Send status of the TV to the HDMI CEC using the TV enabled device Turn off the operating device by pressing When switching the TV's external input the power button for three seconds or or channel. more, and turning off the TV. When switching the TV's menu language. * Some device may not support this * Information regarding behaviour of the function. For more details refer to the device when status is received, refer to device's manual. the external device's manual. side or rear of this unit e.g.) HDMI OUT HDMI cable T TLE 5 CHAPT R 5 REPEAT -B BD/DVD recorder or with the HDMI output jack Note: • This unit accepts 480i / 480p / 720p / 1080i video signals, and 32kHz / 44.1kHz / 48kHz audio signals. • This unit accepts only 2 channel audio signal (LPCM). • You need to select "PCM" for the digital audio output of the device you connected or check the HDMI audio setting. There may be no audio output if you select "Bitstream", etc. • This unit only accepts signals in compliance with EIA861. [HDMI-DVI Connection] Use an HDMI-DVI conversion cable to connect the unit to external video devices equipped with DVI output jack. e.g.) DVI OUT HDMI-DVI conversion cable rear of this unit S ER O PM cable receiver or satellite box with the DVI output jack AUDIO OUT L R To HDMI1 input jack only RCA audio cable Note: • This unit accepts 480i / 480p / 720p / 1080i video signals. • HDMI-DVI connection requires separate RCA audio connections as well. • Audio signals are converted from digital to analog for this connection. • DVI does not display 480i image that is not in compliance with EIA/CEA-861/861B. 11 EN