Jensen MS4200RS User Manual - Page 6
IMPORTANT INFORMATION, Connection in vehicles equipped with standard ISO, connectors
View all Jensen MS4200RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
INSTALLATION INSTRUCTIONS IMPORTANT INFORMATION A Only trained specialists should install the unit. A Observe automotive industry quality standards. A Fire hazard! When drilling, care must be taken not to damage concealed wiring harnesses, the fuel tank and fuel lines. A Never drill into supporting or safety-relevant body parts. A Only install in vehicles with 12V negative ground systems. Risk of malfunction, damage and vehicle fire can result if installed in unsuitable vehicles. Connection in vehicles equipped with standard ISO connectors The navigation radio may be installed without major preparation in vehicles equipped with ISO standard connectors. Some signals may have to be connected to ISO connector A (refer to "Connection overview ISO chamber A"). For vehicles with different connection requirements, ask your dealer for special cables for a problem-free installation. Connection in vehicles without standard ISO connectors If no adapter cables are available for your vehicle, connect the navigation radio as described in "Electrical connections". Taking safety precautions, Fig. 1 A Before starting work, disconnect the earth cable from the negative terminal of the vehicle battery in order to prevent short circuits. For this purpose, follow the vehicle manufacturer's safety instructions (alarm system, airbag, immobilizer, etc.). Making the electrical connections Route all wiring with care. For wiring, refer to the connection diagram on the cover pages and the following table Do not cut non-assigned wires. Instead, wind them together and secure to one side. They may be required for retrofitting additional functions. Depending on the manufacturer of the connecting and adapter cables, they may deviate from the ones shown here. 3