Kenmore 9751 Use and Care Manual - Page 35

Self Cleaning Stopping or Interrupting a Self-Cleaning Cycle If it becomes necessary to stop or interrupt a self-cleaning cycle due to excessive smoke or fire in the oven: 1. Press . 2. The oven door can only be opened after the oven has cooled down for approximately 1 HOUR and the «DOOR LOCKED" icon is no longer displayed. Note: If your clock is set for normal 12 hour display mode the Delayed Self-Clean cycle can never be set to start more than 12 hours in advance. To set for Delayed Self-Clean Cycle 12-24 hours in advance set the control for the 24 hour time of day display mode. Adjusting Oven Temperature The temperature in the oven has been pre-set at the factory. When first using the oven, be sure to follow recipe times and temperatures. If you think the oven temperature is cooking too hot or too cool for the temperature you select, you can adjust the actual oven temperature to be more or less than what is displayed. Before adjusting, test a recipe by using a temperature setting that is higher or lower than the recommended temperature. The baking results should help you to decide how much of an adjustment is needed. Instructions PRESS To adjust the oven temperature 1. Press . 2. Press and hold for 6 seconds. UPO (User Programmable Offset) and the preset adjustment number will appear and "LOWER" will flash in the display (Fig. 1). 3. To increase the temperature use the number pads to enter the desired change. (Example 30°F) 3 0 (Fig. 2). The temperature may be increased as much as 35°F (19°C). To decrease the temperature use the number pads to enter the desired change. (Example -30°F) 3 0 and then press (Fig. 3). The temperature may be decreased as much as 35°F (19°C). 4. Press to accept the temperature change and the display will return to the time of day. Press to reject the change if necessary. 3 0 3 0 NOTE: Each oven may be adjusted individually. Note: The oven temperature adjustments made with this feature will not change the Self-Clean cycle or Broil temperature. DISPLAY Fig. 1 Fig. 2 Fig. 3 35