Kenwood DDX7015BT Operation Manual - Page 68

CONNECTION/INSTALLATION Connection R Connecting wires to terminals (for DDX7015BT/DDX5902) Pages 70 - 71 USB terminal (0.8 m): Pages 70 - 71 Page 72 8 Pages 70 - 71 Purple with white stripe (Reverse sensor wire) Connect to the vehicle's steering remote harness. Contact your Kenwood dealer for details.*1 Connect to the vehicle's reverse lamp harness when using the optional rear view camera. Connect the antenna cord to the antenna terminal. Light green (Parking 10 A fuse sensor wire) 3 Connect SiriusXM Connect Vehicle Tuner (commercially available). See page 71.*2 Connect to the vehicle's parking brake detection switch harness. • For best safety, be sure to connect the parking sensor. 1 White ª / White with black stripe · : To front speaker (left) Gray ª / Gray with black stripe · : To front speaker (right) Green ª / Green with black stripe · : To rear speaker (left) Purple ª / Purple with black stripe · : To rear speaker (right) *3 Blue (Antenna control wire) Blue with white stripe (Power control wire) Brown (Mute control wire) Light blue with yellow stripe (Steering remote control wire) Orange with white stripe (Dimmer control wire) Red (Ignition wire) Yellow (Battery wire) Black (Ground wire) 68 (ACC) (BATT) (GND) *1 Only for DDX7015BT. *2 Only for DDX5902. *3 If no connections are made, do not let the cable come out from the tab. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. (Max. 300 mA, 12 V) When using the optional power amplifier, connect to its power control terminal. Not used. To use the steering wheel remote control feature, an exclusive remote adapter (not supplied) matching your car is required. To car light control switch Ignition key switch To car chassis Fuse box Battery