Kenwood DNX573S Quick Start Guide - Page 27
Connecting wires to terminals, ILLUMI, P. CONT, PRK SW, REVERSE
View all Kenwood DNX573S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installation ÑÑConnecting wires to terminals Connect to the vehicle's parking brake detection switch harness. PRK SW Ignition key switch Light Green (Parking sensor wire) For best safety, be sure to connect the parking sensor. ACC Red (Ignition wire) Yellow (Battery wire) Fuse (15A) Accessory 1 White + White/Black Gray + Gray/Black Green + Green/Black Purple + Purple/Black Purple/White (Reverse sensor wire) REVERSE Light Blue/Yellow (Steering remote control wire) REMOTE CONT STEERING WHEEL REMOTE INPUT Speaker impedance: 4-8 Ω To front left speaker To front right speaker To rear left speaker To rear right speaker If no connections are made, do not let the cable come out from the tab. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote To use the steering wheel remote control feature, you need an exclusive remote adapter (not supplied) matched to your car. Car fuse box Black (Ground wire) ¤ (To car chassis) Orange/White (Dimmer control wire) ILLUMI To car light control switch Battery Blue (Antenna control wire) ANT CONT Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. (Max. 300mA, 12V) Blue/White (Power control wire) P. CONT When using the optional power amplifier, connect to its power control terminal. English | 27