Kenwood KDC-MP2032 Instruction Manual - Page 27
Connecting Wires to Terminals - wiring harness
UPC - 019048164599
View all Kenwood KDC-MP2032 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Connecting Wires to Terminals REMO. CONT To Wired remote controller (KDC-232MR only) To Kenwood disc changer/ External optional accessory (KDC-MP2032/MP232/232MR only) To connect these leads, refer to the relevant instruction manuals. FRONT Front right output (Red) (KDC-MP2032 only) Front left output (White) (KDC-MP2032 only) Rear left output (White)/ Rear right output (Red) Fuse (10A) FM/AM antenna input If no connections are made, do not let the wire come out from the tab. Wiring harness (Accessory1) Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. P.CONT Power control/Motor antenna control wire (Blue/White) Connect to the terminal that is grounded when either the telephone rings or during conversation. MUTE To connect the KENWOOD navigation system, consult your navigation manual. TEL mute wire (Brown) Do not let the wire come out from the tab. ANT. CONT Not Used (Blue) To front left speaker White/Black White To front right speaker Gray/Black Gray To rear left speaker Green/Black Green To rear right speaker Purple/Black Purple FRONT L FRONT R REAR L REAR R Ignition key switch Car fuse box ACC Ignition wire (Red) Car fuse box (Main fuse) Battery + - Battery wire (Yellow) Ground wire (Black) - (To car chassis) English | 27