Kenwood TK-3360 Operation Manual 2 - Page 23
Priority Scan
View all Kenwood TK-3360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
3 Press the PTT switch and speak into the microphone. Release the PTT switch to receive. • For best sound quality, hold the transceiver approximately 1.5 inches (3 ~ 4 cm) from your mouth. • If signaling has been programmed on the channel, you will hear a call only if the received signal matches your transceiver settings. SCAN Scan monitors for signals on the transceiver channels. While scanning, the transceiver checks for a signal on each channel and only stops if a signal is present. To begin scanning, press the key programmed as Scan. • When a signal is detected on a channel, Scan pauses at that channel. The transceiver will remain on the busy channel until the signal is no longer present, at which time Scan resumes. To stop scanning, press the Scan key again. Note: To use Scan, there must be at least 2 channels in the scan sequence. PRIORITY SCAN If a Priority channel has been programmed, the transceiver will automatically change to the Priority channel when a call is received on that channel, even if a call is being received on a normal channel. If the Priority channel has been set as Operator Selectable by your dealer, you can set a new channel as the Priority channel by selecting your desired channel and pressing the key programmed as Priority Channel Select. 13