Kenwood VR-517 User Manual - Page 30

Basic remote control operations for other components (For VR-506/517/KRF-V6050D/V5550D) The remote control supplied with this receiver (for VR-506/517/ 30 KRF-V6050D/V5550D only) is also capable of controlling components from a variety of manufacturers once you register the appropriate setup codes into the remote control unit. Low battery warning Replace all four batteries with new ones when you notice a shortening of the distance from which the remote control will operate. The remote control is designed to retain setup codes in memory while you change batteries. Registering setup codes for other components Numeric keys POWER Source POWER keys 4 Repeat steps 2 to 3 to register additional components until all components have been registered. Note Although each setup code is designed to work with a number of different models, certain codes may not work with some models. (Also, certain codes may only operate some of the functions available on a given model.) Operating other components This operation lets you operate the registered components. KENWOOD audio components with system control turn on and off automatically with the receiver via the system control connections. POWER Source POWER keys RECEIVER RC-R0615/R0617 1 Find the setup code of the component to be registered. • Refer to the setup code lists to find the setup code for the component to be registered. ⁄ Example: To register a DVD made by KENWOOD, you would enter "805". Input (DVD) Component Maker Code DVD player KENWOOD 805, 808 Key DVD RC-R0615/R0617 1 Use the input selector keys to select the component you desire. • Pressing the input selector keys also changes the input selector on the receiver. • When you operate your registered TV, VCR, DVD player, Cable tuner, or DSS receiver, go to step 2. • When you operate the CD player, Cassette deck, MD player, or Tuner with system control connection, go to step 3. 2 Press the source POWER key. Remote Control 3 Press the operation keys you desire. › • To return to the receiver operation mode, press the RECEIVER key. The remote control mode returns to the receiver operation mode when you do not operate for more than 15 seconds. 2 Hold down the POWER key and press the numeric keys to enter the setup code. • Example: Press "805" to register a DVD player made by KENWOOD. • If you push an invalid key, the remote will exit the setup mode. 3 Press the source POWER (TV, VCR, DVD, CABLE, DSS)key for more than 2 seconds, and check to see that the component you want to control turns on. If the component does not react, and there is more than one setup code, enter another setup code and try again. • 6, TUNING 1/¡, or MULTI CONTROL key(s) can also be used instead of the POWER key. • If the component is already on, pressing the source POWER keys will turn it off. Note Be sure to point the remote control at the remote sensor on the receiver when you want to operate KENWOOD components connected by system control cords. Otherwise, point the remote control at the component you want to operate.