Kenwood VR-517 User Manual - Page 40
Remote control unit, Additional Information, In case of difficulty
View all Kenwood VR-517 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
In case of difficulty Remote control unit 40 Symptom Certain inputs cannot be selected using the remote control. Remote control operation is not possible. Cause Remedy • No setup codes registered at for the respective • Register a setup code at the respective input(s). input(s). º • The remote control is set to a different operation mode. • Batteries are exhausted. • The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle between the receiver and the remote. • The audio cords and system control cords are not connected properly. • No software is loaded in the source component. • An attempt is made to play a tape which is being recorded in the cassette deck. • The remote control has not been set to the operation mode for the component you wish to control. • The microprocessor of the remote control malfunctions. • Press the source select keys or source POWER keys to select the appropriate operation mode. • Replace with new batteries. • Operate the remote control unit within the con- trollable range. • Connect properly referring to "Setting up the system". • Place software in the source component you want to play. • Wait until recording has completed. • Press the source select keys or source POWER keys to activate the operation mode for the component you want to control before opera- tion. ª • Reset the microprocessor. Additional Information