Kenwood VR-5700 User Manual - Page 84
Receiver/Tuner
View all Kenwood VR-5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Moving Around Receiver/Tuner I want to clear all the items in Remote Control unit and make it to the factory-set default condition. 1. Remove the batteries. 2. While holding the (function up) button and button simultaneously, load the batteries. After the above, all settings are reset to the factory settings. The RF remote control function does not work. • Connect the antenna. See page 33 of the Connections and Setup Guide. • Make sure that the correct RF band is selected. See page 43 of the Connections and Setup Guide. • The operation range of the Remote Control unit will be influenced according to the material of the obstacles between the Remote Control unit and the receiver. Please confirm that there is no such influence. • Make sure that no interference from electrical appliances occurs. Receiver/Tuner My receiver won't turn on and the STANDBY indicator is flashing Your receiver is in the "protection" mode. Check that: • The speaker system's impedance is not too low. See Chapter One of the Connections and Setup Guide. • The speaker wires are not short-circuited. Test the wires as follows to find the shorted wire and replace it: 1 Turn off the receiver, disconnect the positive and negative speaker wires of the RIGHT FRONT speaker from the receiver, and turn the receiver back on. 2 If the STANDBY indicator stops flashing, replace this wire. 3 If the STANDBY indicator does not stop flashing, turn off the receiver, reconnect the speaker wires, and repeat the first step for the next speaker. 4 Continue until you have isolated and replaced the shorted wire. 5 See Chapter One of the Connections and Setup Guide. 76 Troubleshooting