KitchenAid KBFO42FTX Installation Guide - Page 18

Refrigerator 24¹⁄₈" (61.3 cm) 23 60.3 cm) 23¹⁄₂" (59.7 cm) Recessed Inset Installation Dimensions 1. Measure the distance from point A (as shown) to back wall. A Side Trim ¹⁄₄" (6.35 mm) 4.7 mm) 5.5 mm) 4.5 mm) 10 mm) ⁵⁄₈" (15.7 mm) Inset Installation Dimensions 1. Measure the distance from point A (as shown) to the back wall. Add 5.6 mm) to this measurement to allow the side panel to fit into the trim. 2. Rout the front edge of the support board or attach a ¹⁄₄" (6.35 mm) board to hold the panel in the cabinet side trim. Overlay Series Custom Side Panels Custom side panels may be needed when not enough space is available to have cabinets on both sides of the refrigerator or when the refrigerator is placed and the end of a cabinet run. You may choose an Inset or Recessed Inset panel installation. Refrigerator and Side Trim Dimensions The width and height of a side panel are determined by the type of installation you are planning. NOTES: ■ The dimensions shown are actual product dimensions and may not reflect the needed installation dimensions. ■ The side panel should be a minimum of ¹⁄₂" (1.27 cm) thick to avoid warping. ■ If the opening depth is 25" (63.5 cm) or more, you may want to install a support board on the rear wall. Refrigerator (36" [91.4 cm] Models) Overlay 23 60.16 cm) A 2. If the panel is more than ¹⁄₄" (6.35 mm) thick, rout the front edge to allow the side panel to fit into the trim. Flush Installation Dimensions 1. Measure the distance from point A (as shown) to the back wall. A 2. Attach the support board with a screw or adhesive that is compatible with aluminum and wood. 18