KitchenAid KERA205PWH User Guide - Page 12

Timer The Timer counts down the set time. On models with electronic oven control Style 1, the timer can be set in minutes and seconds or hours and minutes. NOTE: The Timer does not start or stop the oven. 1. Press TIMER SET/START. 3. Press TIMER SET/START to start the timer. When the set time ends, timer completion tones will sound, then reminder tones will sound every 10 seconds. 4. Press TIMER OFF anytime to cancel the Timer and/or stop reminder tones. On models with electronic oven control Style 1, press again to switch from MIN/SEC and HR/MIN. 2. Press the number pads to set length of time. Remember, if OFF is pressed, the oven will turn off. 5. The time can be reset during the countdown by repeating the above steps. OPTIONS - STYLE 1 Options Selection Pad The OPTIONS selection pad allows you to access special functions within the Electronic Oven Control that allow you to customize the product to your needs. These special functions allow you to change the oven temperature between Fahrenheit and Celsius, turn the audible signals and prompts on and off, and adjust the oven calibration. The Sabbath Mode is also set using the OPTIONS selection pad. To Use: Press OPTIONS. The oven display will scroll through the various options, starting at 1 and ending in 7. You can also press the OPTIONS selection pad and number pad to quickly access the desired hidden function. OPTIONS SPECIAL FUNCTION 1 Fahrenheit and Celsius conversion 2 Tones On and Off 3 Tones High and Low 4 Cooking Time Completion Tones On and Off 6 Oven Temperature Calibration 7 Sabbath Mode Preheat Completion Tone One chime indicates a preheat cycle has been completed. All Tones All tones are preset ON, but can be turned OFF. To turn tones ON, press the options key, then press keypad 2. To turn tones OFF, press the options key again, and then press keypad 2. Tone Volume The volume is preset at high, but can be changed to low. To Change: Press OPTIONS, and then 3 to lower the volume. Press OPTIONS, and then 3 to raise the volume of the tones. Oven Temperature Calibration IMPORTANT: Do not use a thermometer to measure oven temperature because opening the oven door during cycling may give incorrect readings. The oven provides accurate temperatures; however, it may cook faster or slower than your previous oven, so the temperature calibration can be adjusted. It can be changed in Fahrenheit or Celsius. A minus sign means the oven will be cooler by the displayed amount. The absence of a sign means the oven will be warmer by the displayed amount. Use the following chart as a guide. Fahrenheit and Celsius Press options, then 1 on the keypad for Celsius. Repeat to convert back to Fahrenheit. ADJUSTMENT °F (AUTOMATIC °C CHANGE) 10°F (5°C) COOKS FOOD ...a little more Tones Tones are audible signals, indicating the following: One beep s Function has been entered Three beeps s Invalid pad press Timer Completion Tones Four chimes occur when the timer reaches zero. This can occur when using the timer for functions other than cooking. Cooking Time Completion Tones Three beeps indicate the end of a cooking cycle. To turn On/Off: Press OPTIONS, and then 4 to turn OFF. Press OPTIONS, and then 4 to turn ON. 20°F (10°C) 35°F (15°C) -10°F (-5°C) -20°F (-10°C) -35°F (-15°C) ...moderately more ...much more ...a little less ...moderately less ...much less To Adjust Oven Temperature Calibration: 1. Press OPTIONS, and then 6 to set the calibration. 2. Press 3 to increase the temperature, or press 6 to decrease the temperature. 3. Press START to end calibration. 12