KitchenAid KGCU463VSS Installation Guide - Page 18

To Convert Grill Burner (on some models) 1. Remove grill grate, wave plate, flame spreader and burner assembly. See "Install Grill Grease Trays" section for removal instructions. Set parts aside. 2. Use a ½" deep-well socket and remove the LP gas orifice hood. Replace with correct grill Natural gas orifice hood. See "Natural Gas Orifice Spud/Hood Chart." A A. Grill orifice hood location 3. Turn Natural gas orifice hood down tightly onto orifice base. 4. Place LP gas orifice hoods in plastic parts bag for future use and keep with package containing literature. 5. Open shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. REMEMBER: Once you have completed converting the grill, test the cooktop for leaks by brushing on an approved noncorrosive leak-detection solution. Bubbles will show, indicating a leak. Correct any leaks found. 6. Plug in cooktop or reconnect power. Complete Installation 1. Refer to the "Make Gas Connection" section for properly connecting the cooktop to the gas supply. 2. Refer to the "Electronic Ignition System" section in the "Complete Installation" section for proper burner ignition, operation, and burner flame adjustments. IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner. Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" (0.64 cm) to ½" (1.3 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. STRIP CIRCUITS Griddle 120V Control Wiring Diagram To Cooktop Stand-Alone R P2-1 P1-1 OR/W 1320W/120V OR/W Lamp 120V BU W Rotary Control P1-3 W P1-4 V W RTD W WV V W P2-6 P1-6 OR/W Grill Reignition Wiring Diagram To Cooktop Stand-Alone and Freestanding BK BR BR Lamp 120V Reignition Module BU W W 18