KitchenAid KGRS505XSS Installation Guide - Page 4
Product Dimensions, Cabinet Dimensions - stainless steel
UPC - 883049199481
View all KitchenAid KGRS505XSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Mobile home installations require: ■ When this range is installed in a mobile home, it must be secured to the floor during transit. Any method of securing the range is adequate as long as it conforms to the standards listed above. Product Dimensions B* B D C A E F J I G KL H C** 8½" (21.6 cm) A D E*** F A. 35 90.8 ± 0.3 cm) cooktop height (minimum) with leveling legs screwed all the way in B. Model/serial/rating plates (located behind the control panel)* C. 47 119.7 ± 0.3 cm) overall height (minimum) with leveling legs screwed all the way in** D. 28 72.4 ± 0.6 cm) depth with handle E. 26¹⁄₈" to 27 66.4 ± 0.3 cm)*** F. 29 76.0 ± 0.2 cm) width *Model/serial/rating plates may be rotated up from behind the control panel for viewing from the front of the range. **Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. ***Excludes handle. Dimension given is from wall to front of oven door and will vary based on electrical outlet receptacle installation. Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. Range may be installed with zero clearance to combustible construction at the rear and on the sides below the cooktop. 1½" (3.8 cm) 14" *** (35.6 cm) 2¼" (5.7 cm) 1¼"* (3.1 cm) 8½" (21.6 cm)** gas line location A. 18" (45.7 cm) upper cabinet to countertop B. 13" (33.0 cm) upper cabinet depth C. 30" (76.2 cm) min. opening width D. For minimum clearance to the top of the cooktop, see NOTE. E. 30" (76.2 cm) min. opening width F. 3" (7.6 cm) min. clearance from both sides of the range to the side wall or other combustible material. G. Cabinet door or hinges should not extend into the cutout. H. 3" (7.6 cm) distance from wall I. 1 ¹⁄₂" (3.8 cm) min. from right side cabinet J. 8" (20.3 cm) width K. 7" (17.8 cm) min. from floor L. 2" (5.1 cm) min. from floor *Drill on centerline 1¼" (3.1 cm) from rear wall for gas supply line. **Gas lines must be installed within the shaded area to ensure proper alignment of this oven with cabinets. ***Electrical plugs must be installed within the shaded area to ensure proper alignment of this oven with cabinets. NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is covered by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet. 4