Konica Minolta bizhub 5000i bizhub 5000i/4000i User Guide - Page 204
Load and Print Using the Multi, Replace the Imaging Unit
View all Konica Minolta bizhub 5000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
Error Message Self-Diagnostic Size Error Size Error 2-sided Size Mismatch Supplies Drum End Soon Supplies Replace Drum Supplies Toner Low Too Many Trays Unusable Device Cause Action The temperature of the fuser unit does not rise to a specified temperature within the specified time. The fuser unit is too hot. Press and hold to turn off the machine, wait a few seconds, and then turn it on again. Leave the machine idle for 15 minutes with the power on. The paper size defined in the printer driver is not supported by the defined tray. Choose a paper size supported by the defined tray. The paper size specified in the machine's paper size setting is not Press (if required). available for automatic 2-sided Load the correct size of paper in the tray and printing. set the tray for that paper size. The paper in the tray is not the correct size and is not available for automatic 2-sided printing. Choose a paper size supported by 2-sided printing. Paper sizes available for automatic 2-sided printing are Letter, Legal, Mexico Legal, India Legal and Folio. The paper in the tray is not the correct size. Load the correct size of paper in the tray indicated on the LCD and set the size of paper for the tray. Press Retry. The imaging unit is near the end Order a new imaging unit before the LCD of its life. displays Replace Drum. It is time to replace the imaging unit. Replace the imaging unit with a new one. See Related Information: Replace the Imaging Unit. The imaging unit counter was not reset when a new drum was installed. Reset the imaging unit counter. See the instructions included with the new imaging unit. If the LCD displays this message, Order a new toner cartridge now so you have you can still print. The toner it ready when the LCD displays Replace cartridge is near the end of its life. Toner. The number of installed Optional Trays exceeds the maximum number. Reduce the number of Optional Trays. An unsupported USB device has been connected to the USB host connector. Unplug the device from the USB host connector. Related Information • Troubleshooting Related Topics: • Replace Supplies • Load and Print Using the Paper Tray • Load and Print Using the Multi‑purpose Tray (MP Tray) • Replace the Imaging Unit • Clean the Corona Wire 200