Konica Minolta bizhub C3110 bizhub C3110 Copy Functions User Guide - Page 14

4 4 Specifying the method to scan the original Specifying the size of the original to be scanned ([Original Size]) Select the size of the original to be scanned. 1 On the main screen (Copy mode), press the + or , key to select the current setting of the original, then press the Select key. 2 Select the size of the original to be scanned. Settings [Standard Size] [Custom Size] Description Select the original size to scan the original in the standard size such as the metric or inch size. Select this option to scan originals in custom size. Enter the length and width of the original. Scanning a number of originals in several batches ([Separate Scan]) If the number of original sheets is so large that they cannot be loaded into the ADF at the same time, you can load them in several batches and handle them as one job. In [Separate Scan], you can switch between the ADF and Original Glass to scan the originals. 0 This function is available when an optional Hard Disk is installed. 1 Load the original. NOTICE Do not load more than 50 sheets at a time into the original tray, and do not load the sheets up to the point where the top of the stack is higher than the , mark. Doing so may cause a paper jam involving the originals, damage the originals, and/or cause an ADF failure. 2 On the main screen (Copy mode), press the + or , key to select [Separate Scan], then press the Select key. 3 Select [ON], then press the Select key. 4 Press the Start key. The original is scanned. 5 Load the next original, then press the Start key. % If necessary, select [Change Settings] to change the option settings according to the new original. 6 Repeat Step 5 until all originals have been scanned. 7 After all originals have been scanned, select [Finish], then press the Select key. [Copy Functions] 4-2