Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 2-Knife Trimmer User Manu - Page 29

5 - Error Conditions, Problems and Solutions - Quality Problems Side-Trimming problem - the book is not trimmed to the correct size Is SIDE TRIM turned on? Yes No Turn on the SIDE TRIM. Is the correct trim size entered in the touch screen? Make sure the size is at least 2mm less than the book size. Yes No Enter the correct size in the touch screen. Open and then close the top cover of the side-trimmer. Wait for the side-trimmer to reset. Does the problem continue? Yes No Further action is not needed. Turn off the Side-Trimmer at the mains ON/OFF switch. Wait for 5 seconds and then turn on the Side-Trimmer. Does the problem continue? Yes No Further action is not needed. Call your service engineer. Side-Trimming problem - the book is only trimmed on one side This problem is normally caused by incorrect set-up. If the side-trim offset is slightly too large, only one side is trimmed. Is AUTO turned off in the SIDE TRIM window? No Yes Set SIDE TRIM to AUTO. Does the problem continue? Yes No Further action is not needed. If you need to use a custom trim size, enter the trim dimension in the SIDE TRIM window. Make sure the size is at least 2mm less than the book size. Open and then close the top cover of the side-trimmer. Wait for the side-trimmer to reset. Does the problem continue? Yes No Further action is not needed. Turn off the Side-Trimmer at the mains ON/OFF switch. Wait for 5 seconds and then turn on the Side-Trimmer. Does the problem continue? Yes No Further action is not needed. Call your service engineer. Watkiss P2T 2-Knife Trimmer User Manual 25