Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 2-Knife Trimmer User Manu - Page 6

Description of the Side-Trimmer, Installation, CAUTION, How to Get Help, Introduction

Get Konica Minolta bizhub PRESS 1250 PDF manuals and user guides View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

1 - Introduction to the Watkiss P2T 2-Knife Trimmer - Description of the Side-Trimmer Installation Your Side-Trimmer must be installed by a Watkiss approved service engineer. Special knowledge is needed to install the machine. CAUTION: Only connect the machine to a mains power supply of the correct voltage with a good earth-connection. The correct machine-voltage is shown on the label at the mains power supply input on the rear of the machine. If the machine is connected to the wrong supply, the warranty is cancelled. How to Get Help If you have any questions or problems, refer to the problem solving section in this manual (see "Error Conditions, Problems and Solutions" on page 23). Contact your supplier for further help. Description of the Side-Trimmer Introduction The Watkiss Side-Trimmer completes the booklet-making process by trimming the top and bottom edges of the book. The fore-edge of the book is already trimmed by the booklet maker, so this additional module provides a professional solution for full bleed printed work. FIGURE 1. Side-Trimmer P2T Side-Trimmer 2 Watkiss P2T 2-Knife Trimmer User Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
1 - Introduction to the Watkiss P2T 2-Knife Trimmer - Description of the Side-Trimmer
2
Watkiss P2T 2-Knife Trimmer User Manual
Installation
Your Side-Trimmer must be installed by a Watkiss approved service engineer.
Special knowledge is needed to install the machine.
CAUTION:
Only connect the machine to a mains power supply of the cor-
rect voltage with a good earth-connection. The correct machine-voltage is
shown on the label at the mains power supply input on the rear of the
machine. If the machine is connected to the wrong supply, the warranty is
cancelled.
How to Get Help
If you have any questions or problems, refer to the problem solving section in
this manual (see “Error Conditions, Problems and Solutions” on page 23). Con-
tact your supplier for further help.
Description of the Side-Trimmer
Introduction
The Watkiss Side-Trimmer completes the booklet-making process by trimming
the top and bottom edges of the book. The fore-edge of the book is already
trimmed by the
booklet maker, so this additional module provides a profes-
sional solution for full bleed printed work.
FIGURE 1.
Side-Trimmer
P2T Side-Trimmer