Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 2-Knife Trimmer User Manu - Page 35
Paper Jams, Change the Fuses - Side-Trimmer, Introduction, WARNING, Fuse Description, Procedure
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
5 - Error Conditions, Problems and Solutions - Paper Jams Paper Jams 1. Open and then close the top cover of the side-trimmer. 2. Then, if necessary, open the top cover of the side-trimmer and check for paper trimmings or obstructions. Close the top cover of the side-trimmer. 3. If the message still does not clear, use the side-trimmer mains ON/OFF switch. Turn the side-trimmer OFF, wait at least 5 seconds and then turn the side-trimmer ON. If the problem continues, then call your service engineer. Change the Fuses - Side-Trimmer Introduction The Side-Trimmer has two fuses at the power input connector. See Figure 2 on page 3. If either fuse is broken, the Side-Trimmer will not operate. WARNING: Turn OFF the machine and remove the mains power supply cable before you change the fuses. This machine uses two fuses in parallel. WARNING: To avoid the risk of fire, replace fuses using only the same type and rating. Fuse Description • 7A, HRC Quick acting, F • Part Number 730-018 Procedure 1. Turn OFF the Side-Trimmer. 2. Disconnect the Side-Trimmer from the power supply. 3. Check each fuse. 4. If the fuse is broken then replace with a fuse of the correct specification. Result If the fuse breaks again, then call your Watkiss service engineer. Watkiss P2T 2-Knife Trimmer User Manual 31