Konica Minolta bizhub PRESS 1250 EF-102 User Guide - Page 21

bizhub PRESS 1250/1250P/1052

3-4

3.1

Removal Procedures

3

3.1.2

Removing Parts from the Tray

NOTICE

Trays cannot be withdrawn when the machine is not powered. Plug the power cord of the machine into the

outlet, turn on the main power switch, then the sub power switch before removing parts from the tray.

For Envelopes of 100 to 140 mm in Width

The following parts need to be removed when envelopes of the above size have been used.

-

Auxiliary guide/Front

-

Auxiliary guide/Rear

-

Stopper x 2

-

Duct cover x 2

1

Pull out the tray.

2

Remove the 2 stoppers installed on the positioning screws

before removing the auxiliary guides (front/rear).

3

Remove the 4 positioning screws, and then install the 4

screws that have been installed before.

Section	Page
1 Introduction	5
1.1 Introduction	5
1.2 Safety Precautions	6
1.2.1 Notices for Safety	6
1.2.2 Precautions When Replacing Units	7
1.2.3 Caution Labels and Indicators	9
2 Installing Fusing Unit EF-102	12
2.1 Replacement Parts	12
2.2 Installation Procedures	13
2.2.1 Installing EF-102 on the Main Body	13
2.2.2 Installing Parts in the Tray	15
3 Removing Fusing Unit EF-102	19
3.1 Removal Procedures	19
3.1.1 Removing EF-102 from the Main Body	19
3.1.2 Removing Parts from the Tray	21
4 Copy/Print Operation	25
4.1 Loading Envelopes in the Tray	25
4.2 Copy Operation	26
4.3 Print Operation	30
4.4 Adjustment	37
5 Specifications	40

Konica Minolta bizhub PRESS 1250 EF-102 User Guide - Page 21

Removing Parts from the Tray

Page 21 highlights