Kyocera Ai3010 Printing System H Operation Guide - Page 20

Setup TCP/IP, Accept, Settings, Configure Status Reset, Reset Unit, that the unit was reset.

Get Kyocera Ai3010 PDF manuals and user guides View all Kyocera Ai3010 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

4. Select Setup TCP/IP in the Protocols column and change the settings as appropriate. If unsure of the correct Subnet mask, and the first number in the NIC's IP address is from 192 to 254, then use 255.255.255.0 as the Subnet mask. The Base Port Number displayed is one less than the printer's actual port number, this for the default of 9100, the Base Port Number is set to 9099. Host-based lpd requires a port number of 10001, therefore, if using host-based lpd, change the Base Port Number to 10000. 5. Type the sysadm password in the appropriate box and click Accept Settings. After a few seconds, the screen should report that the update was successful. Click the Back Arrow icon twice to return to the NIC Configuration page. 6. Optional: Click on Configure Status Page in the Printer column to define power-up status page settings, (e.g., disabling the power-up status page). 7. The changes made to the NIC do not take effect until the unit is reset. Click on Reset in the System column and click Reset Unit. After a few seconds the screen should report that the unit was reset. TCP/IP configuration is now complete. 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
20
4.
Select
Setup TCP/IP
in the Protocols column and change the settings
as appropriate.
If unsure of the correct Subnet mask, and the first
number in the NIC's IP address is from 192 to 254, then use
255.255.255.0 as the Subnet mask.
The Base Port Number displayed is
one less than the printer's actual port number, this for the default of
9100, the Base Port Number is set to 9099.
Host-based lpd requires a
port number of 10001, therefore, if using host-based lpd, change the
Base Port Number to 10000.
5.
Type the sysadm password in the appropriate box and click
Accept
Settings
.
After a few seconds, the screen should report that the
update was successful.
Click the Back Arrow icon twice to return to
the NIC Configuration page.
6.
Optional
:
Click on
Configure Status Page
in the Printer column to
define power-up status page settings, (e.g., disabling the power-up
status page).
7.
The changes made to the NIC do not take effect until the unit is reset.
Click on
Reset
in the System column and click
Reset Unit
.
After a
few seconds the screen should report
that the unit was reset.
TCP/IP configuration is now complete.