Kyocera KM-3035 KM-Net ServiceGateway Quick Start Guide Rev-1 - Page 8

Step 6 Continued, Step 7

Get Kyocera KM-3035 PDF manuals and user guides View all Kyocera KM-3035 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

KM-Net Service Gateway ) Step 6 Continued 3. For Recipient 1 Address, enter an Internet e-mail address; preferably one that can easily be connected to for delivery verification. 4. Under Event Reports, click the Cover Open checkbox. 5. For E-mail Interval, enter 1 minute. 6. Click Submit. The IB-21e version 1.33 or later has the "send" button on this page to send an email for testing. Customer Site - Verify E-mail Delivery Figure 5. E-mail Recipient for Internet E-mail Verification 7. Open one of the printer's covers. Wait a couple minutes and then check your Internet e-mail account to see if it received the error report e-mail. If it did, then the customer's mail server is set to allow POP3 clients to send to the Internet and the printer's e-mail reports should be able to be received by the ServiceGateway. When finished, be sure to eliminate these test settings made to the E-mail Recipient 1 page. If the test error report e-mail is not received, then most likely the customer's mail server configuration needs to be modified. Note: There is a "send" button for sending test e-mail reports in IB-21E version 1.3.0 or higher. ) Step 7 Customer Site - Mail Server Modifications If the test e-mail in the previous section was successful, then no modifications to the mail server are necessary and you may proceed to Step 8. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
KM-Net Service Gateway
8
Step 6 Continued
3. For
Recipient 1 Address
, enter an Internet e-mail address; preferably one that can easily be
connected to for delivery verification.
4. Under
Event Reports
, click the
Cover Open
checkbox.
5. For
E-mail Interval
, enter 1 minute.
6. Click
Submit
.
The IB-21e version 1.33 or later has the “send” button on this page to send an email for testing.
Customer Site – Verify E-mail Delivery
Figure 5. E-mail Recipient for Internet E-mail Verification
7.
Open one of the printer's covers. Wait a couple minutes and then check your Internet e-mail
account to see if it received the error report e-mail.
If it did, then the customer's mail server is set to allow POP3 clients to send to the Internet and
the printer's e-mail reports should be able to be received by the ServiceGateway.
When finished, be sure to eliminate these test settings made to the E-mail Recipient 1
page.
If the test error report e-mail is not received, then most likely the customer's mail server
configuration needs to be modified.
Note: There is a “send” button for sending test e-mail reports in IB-21E version 1.3.0 or higher.
Step 7
Customer Site – Mail Server Modifications
If the test e-mail in the previous section was successful, then no modifications to the mail server are
necessary and you may proceed to Step 8.