Kyocera TASKalfa 3510i 3010i/3510i Operation Guide - Page 467

Troubleshooting > Troubleshooting Adjustment/Maintenance Tone Curve Adjustment After prolonged use, or from the effects of surrounding temperature or humidity, the printed output tone may differ from the original. Perform this function to ensure consistency with the original tone. NOTE To perform tone curve adjustment, verify that either Letter or A4 paper is loaded into a cassette. A total of 2 pattern pages (No. 1 and 2) are printed during adjustment. The printed patterns are read sequentially during the adjustment. 1 Display the screen. 1 Press the [System Menu] key. 2 Press [ ], [Adjustment/Maintenance], [ ] and then [Next] of "Tone Curve Adjustment". 2 Adjust the tone curve. 1 Press [Start]. A pattern is printed. Check that the number "1" is printed at the bottom of the pattern. 2 As shown in the illustration, place the printed side down on the platen with the edge with the arrows toward the back. 3 Press [Start]. The pattern is read and adjustment begins. The second pattern is output. 4 Check that the number "2" is printed at the bottom of the pattern and repeat steps 2 to 3 to read the pattern. 5 Press [OK] in the adjustment end confirmation screen. 10-33