LG DLEX7600VE Owners Manual - Page 20
Install the hinge on the top left side of
View all LG DLEX7600VE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
20 INSTALLATION 15 Reinstall the side interlock button. Reinstall the side interlock button removed in step 7. Center the spring in the compartment and insert the interlock button on top of it. 17 Now, pick up the upper hinge pivot removed earlier and rotate it 180 degrees. Install the hinge on the top left side of the cabinet. 16 Reinstall the door cover. Clean the glass on the door and door cover, if necessary. Make sure the three gray interlock buttons are properly installed and that the top and side lock rods are properly aligned where they meet. Carefully lower the door cover into place, aligning the holes in the cover with the interlock buttons on the top and side and the bumpers on the bottom. Take care not to dislodge the lock rods while mounting the door cover. Once the door cover is in place, secure it with the 12 screws removed in step 4. The ten similar screws go around the top and sides of the door cover. Make sure to install the two different screws on the bottom edge, in the locations marked below. 18 Reinstall the door. Press in the side interlock button on the left side and hold it down while you press the hinge pivot into the hinge assembly on the top right side. If the door has been reassembled correctly, the lock rod will slide back easily and lock the pivot in place. The door is now ready to remount on the opposite side of the dryer. Two large screws Interlock buttons Side interlock button Bumpers Two small screws While supporting the door, install the two small hinge screws removed in step 2. Test the swing of the door to make sure the hinges and latch are properly aligned and that the door opens, closes and latches properly in both directions. If the door doesn't operate smoothly, remove the door and then the door cover to check that the lock rods and interlock buttons are properly mounted and aligned. The interlock buttons should be oriented correctly and operating smoothly. The interlock rods should be in the proper position and should not overlap at the contact point. (See steps 15-17.) If the door is damaged, or if the door does not work after reassembly, contact the call center at 1-800-243-0000.