LG DLEX7600VE Owners Manual - Page 32
Installation Test Duct Check
View all LG DLEX7600VE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
32 INSTALLATION Installation Test (Duct Check) Once you have completed the installation of the dryer, use this test to make sure the condition of the exhaust system is adequate for proper operation of the dryer. This test should be performed to alert you to any serious problems in the exhaust system of your home. •• Your dryer features Flow Sense™, an innovative sensing system that automatically detects blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use. NOTE The dryer should be cool before starting this test. If the dryer was warmed up during installation, run the AIR DRY cycle for a few minutes to reduce the interior temperature. To activate the installation test: 1 Remove the drying rack and literature, and then close the door. Do not load anything in the drum for this test, as in may affect the accuracy of the results. 2 Press the Power button then immediately press and hold both the Temp. and Signal buttons until appears in the display. 3 Press the START/PAUSE button. The dryer will start the test, which will last about 2 minutes. The heat will be turned on and the temperatures in the drum will be measured. 4 Check the display for results. During the test cycle, monitor the Flow Sense™ display on the control panel. If no bars are displayed, when the cycle ends, the exhaust system is adequate. If the exhaust system is severely restricted, the display will show four bars. Other problems may also be shown with error codes. Refer to the next page for error code details and solutions. NO BARS: OK FOUR BARS: RESTRICTED Four bars indicates that the exhaust system is severely restricted. Have the system checked immediately, as performance will be poor. 5 End of cycle. At the end of the test cycle, will display. The test cycle will end and the dryer will shut off automatically after a short delay. •• Check the error code before you call for service Error Code tE1 or tE2 HS PS or PF or nP Possible Causes •• Temperature sensor failure. •• Humidity sensor failure. •• Electric dryer power cord is not connected correctly, or house power supply is incorrect. •• House fuse is blown, circuit breaker has tripped, or power outage has occurred. Solutions •• Turn off the dryer and call for service. •• Turn off the dryer and call for service. •• Check the power supply or the connection of the power cord to the terminal block. Refer to the Connecting Electric Dryers section of this manual for complete instructions. •• Reset circuit breaker or replace fuse. Do not increase the fuse capacity. If the problem is a circuit overload, have it corrected by a qualified electrician.