LG DLEX7600VE Owners Manual - Page 24
Connecting the Inlet Hose, Steam Models
View all LG DLEX7600VE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
24 INSTALLATION Connecting the Inlet Hose (Steam Models) The dryer must be connected to the cold water tap using a new water supply hose. Do not use old hoses. NOTE •• Water supply pressure must be between 20 and 120 psi (138-827 kPa) . •• Do not strip or cross-thread when connecting the inlet hose to the valve. •• If the water supply pressure is more than 800 kPa, a pressure-reducing valve should be installed. •• Periodically check the condition of the hose and replace the hose if necessary. •• Replace inlet hoses after 5 years of use to reduce the risk of hose failure. •• Record hose installation or replacement dates on the hoses for future reference. 1 Check the rubber seal at each end of the inlet hoses. Two rubber seals are supplied with each inlet hose. They are used for preventing water leaks. Make sure the connection to the cold water tap is tight. Hose connector Rubber seal Y connector 2 Check the installation type. d. Connect the long dryer hose to one side of the Y-connector and connect the washer hose to the other side. WITHOUT WASHER: If the dryer does not share the cold water tap with a washer. a. Connect the straight end of the long hose to the cold water faucet. NOTE •• Before connecting the water line to the dryer, flush several gallons of water into a drain or bucket. This will help prevent foreign particles such as sand and scale from clogging the dryer inlet valve. •• Do not overtighten. Damage to the coupling may result. 3 Connect the hose to the dryer. Connect the water supply hose to the dryer inlet valve tightly by hand and then tighten another 2/3 turn with pliers. Make sure that there are no kinks in the hoses and that they are not crushed. 4 Turn on the cold water faucet. Short hose Y connector Long hose WITH WASHER WITHOUT WASHER 5 Check for leaks at the Y-connector (if used) and in all hoses. Connect all water supply hoses tightly by hand and then tighten another 2/3 turn with pliers. WITH WASHER: When connecting the dryer to the same faucet as a washer. a. Shut off the cold water tap and remove the washer hose. b. Connect the short hose to the Y-connector using one of the rubber seals. c. Connect the other end of the short hose to the cold water faucet. NOTE •• If any leaks are found, shut off the water faucet, remove the hose and check the condition of the rubber seal.