LG DLG5932W Service Manual - Page 7

3 INSTALLATION INSTRUCTIONS 3-1. POWER CORD 1) 4-wire connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3 wire connections. 3. Connect ground wire (green or bare) of power supply cable to external ground conductor screw. Tighten screw. 4. Connect neutral wire (white or center wire) of power supply cord to the center, silver colored terminal screw of the terminal block. 1 2 6 34 5 7 1. 4-wire receptacle (NEMA type 14-30R) 2. 4-prong plug 3. Ground prong 4. Neutral prong 5. Spade terminals with upturned ends 6. 3/4 in. (1.9 cm) UL approved strain relief 7. Ring terminals 1. Remove center terminal block screw. 2. Remove appliance ground wire (green) from external ground connector screw. Fasten it under center, silver colored terminal block screw. 1 2 3 1 4 5 2 6 3 1. External ground connector 2. Green or bare copper wire of power supply cord 3. 3/4 in. (1.9 cm) UL-listed strain relief 4. Center silver-colored terminal block screw 5. Neutral grounding wire (green) 6. Neutral wire (white) 5. Connect the other wires to outer terminal block screws. Tighten screws. 6. Tighten strain relief screws. 7. Insert tab of terminal block cover into slot of dryer rear panel Secure cover with hold-down screw. 1. External ground connector - Dotted line shows position of NEUTRAL ground wire before being moved to center terminal block screw 2. Center silver-colored terminal block screw 3. Green wire of harness 6