LG LDF5678SS Owners Manual - Page 15
Preparing Water and Electrical Connections, WARNING, CAUTION
View all LG LDF5678SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
14 INSTALLATION Preparing Water and Electrical Connections There are 2 channels in the bottom of the dishwasher for routing the water and electrical connections. As shown in the bottom view below, channel is for the water supply line, and channel is for the electrical cable. 1 Turn off the house water supply and the circuit breaker or dedicated power before connecting the dishwasher. 2 Run the water supply line along the floor 6 1/2 - 7 3/4" (165-197 mm) from the left side of the opening and tape it in place in front of the opening. 3 Run the electrical cable along the floor 14-16" (356-406 mm) from the water supply line and tape it in place. • The electrical outlet must be within 4 ft. (1.22 m) of either side of the dishwasher. • The best location for the electrical conduit is on the right side of the back wall. Re-route the electrical cable before installation if the electrical conduit pipe is longer than 3" (76 mm) and is centered on the back wall. WARNING Water Connection ••Do not reuse an old hose. Use only a new hose when installing the dishwasher. The old hose could leak or burst causing flooding and property damage. Contact an LG Customer Information Center for assistance in buying a new hose. Electrical Connection ••Use a time-delay fuse or circuit breaker. ••Operate this appliance with the correct voltage as shown in this manual and on the rating plate. ••The wiring must be grounded properly. If in doubt, have it checked by a qualified electrician. ••Connect the appliance using 3-wires, including a ground wire. ••The appliance and outlet must be positioned so that the plug is easily accessible. ••Do not use an extension cable or adapter with this dishwasher. ••Do not overload the outlet with more than one appliance. ••The included 16AWG wire nuts should be used. ••It is the personal responsibility and obligation of the product owner to have a proper outlet installed by a qualified electrician. CAUTION ••When connecting the dishwasher water supply line to the house water supply, sealing tape or compound should be used on pipe threads to avoid leaks. Tape or compound should not be used on compression fittings. ••Connect the dishwasher to a hot water supply with a temperature range between 120 °F (49 °C) and 149 °F (65 °C). This temperature range provides the best washing results and shortest cycle time. To prevent damage to dishes, the temperature should not exceed 149 °F (65 °C). ••Water supply pressure must be between 20 psi and 80 psi (140-550 kPa). If the water supply pressure exceeds 80 psi, a pressure reducing valve must be installed. Otherwise premature failure of the inlet valve may occur.