LG LH-E9674PA Owners Manual - Page 31

Presetting the Radio Stations You can preset 50 stations for FM and AM. Before tuning, make sure that you have turned down the volume. 1. Press BAND on the Remote Control until FM or AM appears in the display window. 2. Press and hold TUN.(-/+) for about two seconds until the frequency indication starts to change, then release. Scanning stops when the unit tunes in a station. 3. Press PROG/MEMO on the Remote Control. A preset number will flash in the display window. 4. Press PRESET +/- on the Remote Control to select the preset number you want. 5. Press PROG/MEMO on the Remote Control again. The station is stored. 6. Repeat steps 3 to 6 to store other stations. To tune in a station with a weak signal Press TUN.(-/+) repeatedly in step 3 to tune in the station manually. Listening to the Radio Preset radio stations in the unit memory first (see "Presetting radio stations" on the left). 1. Press BAND until FM or AM appears in the display window. The last received station is tuned in. 2. Press PRESET +/- repeatedly on the Remote Control to select the preset station you want. Each time you press the button, the unit tunes in one preset station at a time. 3. Adjust the volume by rotating VOLUME on the front panel or by pressing VOLUME + or - on the Remote Control repeatedly. To turn off the radio Press POWER to turn the unit off or select another function mode (DVD/CD, AV 1, etc.,). To listen to non-preset radio stations Use manual or automatic tuning in step 2. For manual tuning, press TUN.(-/+) repeatedly. For automatic tuning, press and hold TUN.(-/+) for about two seconds on the front panel. To clear all the stored stations Press and hold PROG/MEMO for about two seconds and "ERASE ALL" is appeared in the display window and then press PROG/MEMO again, the stations are cleared. If you have accidentally entered into the "ERASE ALL" mode and you do not wish to clear the memory, do not press any key. After a few seconds, the "ERASE ALL" display will go off by itself and change to normal mode. To select a preset radio station directly You can use the number buttons on the Remote Control to select a preset radio station directly. For example, to listen to preset station 4, press 4 on the Remote Control. To listen to preset station 19, press 1 then 9 (within 3 seconds). Note: If all stations have already been entered, the FULL message will appear in the display window for a moment and then a preset number will flash. To change the preset number, follow the steps 5-6 as above. Operation 31