LG LNXS30866D Owners Manual - Page 21

ENGLISH INSTALLATION 21 Leveling After installing, plug the refrigerator's power cord into a 3-prong grounded outlet and push the refrigerator into the final position. The refrigerator has two front leveling legs- one on the right and one on the left. Adjust the legs to alter the tilt from front-to-back or sideto-side. If the refrigerator seems unsteady, or you want the doors to close more easily, adjust the refrigerator's tilt using the instructions below: 1 Turn the leveling leg to the left to raise that side of the refrigerator or to the right to lower it. It may take several turns of the leveling leg to adjust the tilt of the refrigerator. NOTE A flare nut wrench works best, but an open-end wrench will suffice. Do not over-tighten. 2 Open both doors again and check to make sure that they close easily. If the doors do not close easily, tilt the refrigerator slightly more to the rear by turning both leveling legs to the left. It may take several more turns, and you should turn both leveling legs the same amount. Door Alignment Leveling the doors may not be possible when the floor is not level, or is of weak or poor construction. The refrigerator is heavy and should be installed on a rigid and solid surface. Some wood flooring may cause leveling difficulties if it flexes excessively. Refrigerator Door Alignment  If either refrigerator door is lower, open the door, lift it, and turn the hinge bolt using the wrench as shown. (For upper refrigerator doors, use wrench 1 .) (LNXS30866*/LNX23766*)  If the right side door is lower, lift the right side door, and use a pair of long nose pliers (not supplied) to additionally insert a snap ring 3 as shown in the drawing, until the heights are balanced. Height difference Refrigerator left hand door Refrigerator right hand door (LNXC23726*) Refrigerator right hand door (LNXS30866*/LNX23766*)