LG MV1604ST Owner's Manual - Page 26

MAINTENANCE CARE AND CLEANING For best performance and safety, keep the oven clean inside and outside. Take special care to keep the inner door panel and the oven front frame free of food or grease build-up. Never use rough powder or pads. Wipe the microwave oven inside and out, including the hood bottom cover, with a soft cloth and a warm (not hot) mild detergent solution. Then rinse and wipe dry. Use a chrome cleaner and polish on chrome, metal and aluminum surfaces. Wipe spatters immediately with a wet paper towel, especially after cooking chicken or bacon. Clean your oven weekly or more often, if needed. METAL RACK Wash the metal rack with a mild soap and a soft or nylon scrub brush. Dry completely. Do not use abrasive scrubbers or cleaners to clean rack. CLEANING THE GREASE FILTERS The grease filter should be removed and cleaned often, at least once a month. 1. To remove grease filters, slide each filter to the side. Pull filter downward and push to the other side. The filter will drop out. 3. To reinstall the filter, slide it into the back slot, then push up and toward oven center to lock. NOTE: Do not operate the hood without the filters in place. CHARCOAL FILTER REPLACEMENT If your oven is vented inside, the charcoal filter should be replaced every 6 to 12 months, or more often if necessary. The charcoal filter cannot be cleaned. To order a new charcoal filter, contact the Service Center. 1. Remove the two vent grille mounting screws. (2 middle screws) 2. Tip the grille forward, then lift it out 3. Open the door. 4. Push the hook and remove old filter. 2. Soak grease filter in hot water and a mild detergent. Rinse well and shake to dry. Do not use ammonia or place in a dishwasher. The aluminum will darken. Hook 5. Slide a new charcoal filter into place and close the door. The filter should rest at the angle shown and set the clock. 6. Slide the bottom of the vent cover into place. Push the top until it snaps into place. Replace the mounting screws. Turn the power back on at the main power supply and set the clock. - 26 -