LG WM2455HG Owner's Manual (English) - Page 19
Stacking Kit, Stacking Kit Installation - gas dryer
UPC - 048231009171
View all LG WM2455HG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
OPTIONAL ACCESSORIES STACKING KIT This stacking kit includes: •Two (2) side rails •One (1) front rail •Four (4) screws Tools Needed for Installation: • Phillips-head screwdriver STACKING KIT INSTALLATION To ensure safe and secure installation, please observe the following instructions. wWARNING • Incorrect installation can cause serious accidents. • The weight of the dryer and the height of installation make this stacking procedure too risky for one person. Two or more people are required when installing the stacking kit. There is a risk of serious back injury or other injuries. • Do not use the stacking kit with a gas dryer in potentially unstable conditions such as a mobile home. Failure to follow this warning can result in serious injury. • Place the washer on a solid, stable, level floor capable of supporting the weight of both appliances. Failure to follow this warning can result in serious injury. • Do NOT stack the washer on top of the dryer. Failure to follow this warning can result in serious injury. • If appliances are already installed, disconnect them from all power, water, or gas lines and from draining or venting connections. Failure to do so can result in electrical shock, fire, explosion, or death. OPTIONAL ACCESSORIES STACKING KIT INSTALLATION (cont.) Dryer Washer 3 Place the dryer on top of the washer by fitting the dryer feet into the side brackets as illustrated. Avoid finger injuries; do not allow fingers to be pinched between the washer and dryer. Slowly slide the dryer toward the back of the washer until the side bracket stoppers catch the dryer feet. 4 Insert the front rail between the bottom of the dryer and the top of the washer. Push the front rail toward the back of the washer until it comes in contact with the side rail stoppers. Install the two remaining screws to secure the front rail to the side rails. 1 Make sure the surface of the washer is clean and dry. Remove paper backing from the tape on one of the stacking kit side brackets. 36 MFL31245113_ENG.indd 36-37 2 Fit the side bracket to the side of the washer top as shown in the above illustration. Firmly press the adhesive area of the bracket to the washer surface. Secure the side bracket to the washer with a screw on the back side of the bracket. Repeat steps 1 and 2 to attach the other side bracket. 37 2007.10.4 2:32:14 PM