Lenovo 6072BVU User Manual - Page 106
Replacing, system, assembly
View all Lenovo 6072BVU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Replacing the system fan assembly This section provides instructions on how to replace the system fan assembly. Note: When you receive your new system fan assembly, you will receive new rubber mounts. 1. Open the computer cover. See "Opening the cover" on page 84. 2. Locate the system fan connector. See "System board locations" on page 83. 3. Disconnect the system fan assembly cable from the system board. See "System board locations" on page 83. 4. You might have to remove the hard disk drive to gain access to the system fan. See "Replacing a hard disk drive" on page 90. 5. Remove the two rubber mounts from the system fan assembly that connect to the chassis by breaking them or cutting them with a pair of scissors. Once this has been done, remove the rubber mounts from the rear of the chassis. 6. Pull the system fan assembly outward from the chassis. Then lift the system fan assembly out of the chassis. 7. When installing your new system fan assembly, use the new rubber mounts that come with the new system fan. 8. Install the two short rubber mounts in the new system fan assembly as shown. 9. Install the two long rubber mounts into the rear of the chassis as shown. Push the mounts through the holes of the chassis. If necessary, pull the mounts through the holes from inside the chassis. 100 Hardware Maintenance Manual