Lenovo E100 Hardware Maintenance Manual - Page 109
Replacing, power, switch, assembly
View all Lenovo E100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Replacing the power switch/ LED assembly 1. Disconnect the power switch/LED assembly cable from the system board. See "Identifying parts on the system board" on page 85. 2. Remove the front bezel. See "Removing and replacing the front bezel" on page 87. 3. Remove the power switch/LED assembly by disconnecting it from the inside of the bezel. 4. Install the new power switch/LED assembly into the bezel. 5. Route the cable for the new power switch/LED assembly through the hole in the chassis and to the system board. 6. Reinstall the bezel. See "Removing and replacing the front bezel" on page 87. 7. Reconnect the power switch/LED cable to the system board. 8. Go to "Completing the FRU replacement" on page 105. Chapter 8. Replacing FRUs (Type 9626) 103