Lenovo E100 Hardware Maintenance Manual - Page 99
Replacing, power, supply
View all Lenovo E100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Replacing the power supply Attention Never remove the cover on a power supply or any part that has the following label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no servicable parts inside these components. 1. Remove the left-side cover. See "Removing the covers" on page 86. 2. Disconnect all power supply cables from the drives. 3. Disconnect all power supply cables from the system board. See "Identifying parts on the system board" on page 85. 4. At the rear of the chassis, remove the four screws that secure the power supply. 5. Lift the power supply out of the chassis. 6. Install the new power supply and insert the four screws that hold the power supply in place. 7. Reconnect all power supply cables to the system board and the drives. See "Identifying parts on the system board" on page 85. Make sure the cables are correctly routed. 8. Go to "Completing the FRU replacement" on page 105. Chapter 8. Replacing FRUs (Type 9626) 93