Lenovo IdeaCentre K330 Lenovo IdeaCentre K3 Series Hardware Replacement Guide - Page 17

Replacing a memory module

Get Lenovo IdeaCentre K330 PDF manuals and user guides View all Lenovo IdeaCentre K330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Replacing a memory module Attention: Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com. To replace a memory module: 1. Remove the computer cover. Refer to "Removing the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Locate the memory module connectors. Refer to "Locating components". 3. Remove the memory module to be replaced by opening the retaining clips as shown. 4. Position the new memory module over the memory connector. Make sure that the notch on the memory module aligns correctly with the connector key on the system board. Push the memory module straight down into the connector until the retaining clips close. 5. Refer to the "Completing the installation". 14 Hardware Replacement Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
14
Hardware Replacement Guide
Replacing a memory module
Attention:
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the
Safety and Warranty Guide
that was
included with your computer or in the
Hardware Maintenance Manual
(HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at http://consumersupport.lenovo.com.
To replace a memory module:
1.
Remove the computer cover. Refer to “Removing the computer cover”.
Note:
For this procedure, it helps to lay the computer on its side.
2.
Locate the memory module connectors. Refer to “Locating components”.
3.
Remove the memory module to be replaced by opening the retaining clips as shown.
4.
Position the new memory module over the memory connector. Make sure
that the notch
on the memory module aligns correctly with the connector
key
on the system board. Push the memory module straight down into the
connector until the retaining clips close.
5.
Refer to the “Completing the installation”.