Lenovo IdeaCentre K330 Lenovo IdeaCentre K3 Series Hardware Replacement Guide - Page 18

Replacing the hard disk drive

Get Lenovo IdeaCentre K330 PDF manuals and user guides View all Lenovo IdeaCentre K330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Replacing the hard disk drive Attention: Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com. To replace the hard disk drive: 1. Remove the computer cover. Refer to "Removing the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Disconnect the data and power cables from the hard disk drive. 3. Use the plastic handle to slide the hard disk drive out of the drive bay. 4. Slide the new hard disk drive into the drive bay. 5. Twist the drive bay into place. 6. Connect the power and signal cables to the hard disk drive. Refer to "Identifying parts on the system board". Hardware Replacement Guide 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
15
Hardware Replacement Guide
Replacing the hard disk drive
Attention:
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the
Safety and Warranty Guide
that was
included with your computer or in the
Hardware Maintenance Manual
(HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at http://consumersupport.lenovo.com.
To replace the hard disk drive:
1.
Remove the computer cover. Refer to “Removing the computer cover”.
Note:
For this procedure, it helps to lay the computer on its side.
2.
Disconnect the data and power cables from the hard disk drive.
3.
Use the plastic handle to slide the hard disk drive out of the drive bay.
4.
Slide the new hard disk drive into the drive bay.
5.
Twist the drive bay into place.
6.
Connect the power and signal cables to the hard disk drive. Refer to “Identifying
parts on the system board”.