Lenovo NetVista A40p Hardware Maintenance Manual for NetVista 6018, 6058, 6059 - Page 140

v Vital Product Data v Management Information Format (MIF) v Alert on LAN Passwords The following section provides information about computer hardware and software-related passwords. v Power-on Password v Administrator Password v Operating System Password Power-on and Administrator passwords are set in the Setup Utility program. See "Setup Utility program" on page 122 for information about running the Setup Utility. Power-on password: A power-on password denies access to the computer by an unauthorized user when the computer is powered on. When a power-on password is active, the password prompt appears on the screen each time the computer is powered on. The computer starts after the proper password is entered. Removing a power-on password: To service a computer with an active and unknown power-on password, power-off the computer and use the following procedure. Note: On some models, this procedure will also remove the administrator password. 1. Unplug the power cord and remove the top cover. 2. Refer to "A20 system board layout (Type 6269)" on page 146 or "A40/A40P system board layout (Types 6058/6059/6578/6579)" on page 148 to find the recovery jumper. 3. Move the recovery jumper from normal to clear. 4. Power-on the computer. The system senses the change in the position and erases the password. It is necessary to move the jumper back to the previous position. 5. Remind the user to enter a new password when service is complete. Administrator password: The administrator password is used to restrict access to the Configuration/Setup Utility program. If the administrator password is activated, and you do not enter the administrator password, the configuration can be viewed but not changed. 126 Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648, 6649