Lenovo ThinkCentre M57 Hardware Maintenance Manual - Page 135
disconnected
View all Lenovo ThinkCentre M57 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
17. Lower the microprocessor retainer 1 and then lower the lever 3 to secure the retainer. Make sure the lever is securely locked into position. Note: There will be a black plastic cover on the microprocessor retainer to protect the socket on the new system board. When you lock the microprocessor in position, remove the black plastic cover. Place the black plastic cover on the microprocessor retainer of the failing system board. 18. Install the new retention module (if required) on the new system board. 19. Install the new system board into the rear of the chassis until it is fully seated. 20. Place the heat sink 1 into position and lower the lever 2 to secure the heat sink. 21. Reinstall the memory modules on the new system board in the same location as they were on the failing system board. See "Replacing a memory module" on page 119. 22. Reconnect all cables that were disconnected from the system board. See "System board connectors" on page 117. 23. Reinstall the PCI riser. 24. Reinstall the rear fan bracket assembly and connect the fan cable to the system board. 25. Go to "Completing the parts replacement" on page 148. Chapter 9. Replacing FRUs - Ultra SFF Desktop computers 129