Lenovo ThinkCentre M57 Hardware Maintenance Manual - Page 69

Diagnostic Error Code 014-198-XXX Parallel port test aborted 014-199-XXX Parallel port test failed, cause unknown 014-2XX-XXX 014-3XX-XXX Parallel port failure 015-000-XXX USB port Interface Test Passed 015-001-XXX USB port Presence 015-002-XXX USB port Timeout 015-015-XXX USB port External Loopback failure 015-027-XXX USB port Configuration/Setup error 015-032-XXX USB port Device Controller failure 015-034-XXX USB port buffer allocation failure 015-035-XXX USB port Reset condition detected 015-036-XXX USB port Register error 015-040-XXX USB port IRQ failure 015-195-XXX USB port Test aborted by user FRU/Action 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test. See "Updating (flashing) BIOS from a CD-ROM or diskette" on page 494 3. Go to "Undetermined problems" on page 80 1. Go to "Undetermined problems" on page 80 2. Flash the system and re-test. See "Updating (flashing) BIOS from a CD-ROM or diskette" on page 494 3. Replace component under function test 1. External parallel device 2. System board No action 1. Remove USB device(s) and re-test 2. System board 1. Remove USB device(s) and re-test 2. System board 1. Remove USB device(s) and re-test 2. System board 1. Flash the system. See "Updating (flashing) BIOS from a CD-ROM or diskette" on page 494 2. System board System board 1. Reboot the system 2. Flash the system and re-test. See "Updating (flashing) BIOS from a CD-ROM or diskette" on page 494 3. Run memory test 4. System board 1. Remove USB device(s) and re-test 2. System board System board 1. Run setup and check for conflicts 2. Flash the system. See "Updating (flashing) BIOS from a CD-ROM or diskette" on page 494 3. System board Information only Re-start the test, if necessary Chapter 7. Symptom-to-FRU Index 63