Lenovo ThinkCentre M57 Hardware Maintenance Manual - Page 65

Diagnostic Error Code 005-010-XXX 005-011-XXX 005-012-XXX 005-013-XXX Video Signal failure 005-016-XXX Video Simple Pattern test failure 005-024-XXX Video Addressing test failure 005-025-XXX Video Checksum Value error 005-027-XXX Video Configuration/Setup error 005-031-XXX Video Device Cable failure 005-032-XXX Video Device Controller failure 005-036-XXX Video Register error 005-038-XXX System BIOS extension failure 005-040-XXX Video IRQ failure 005-195-XXX Video Test aborted by user 005-196-XXX Video test halt, error threshold exceeded 005-197-XXX Video test warning FRU/Action 1. Video card, if installed 2. System board 1. Video Ram 2. Video card, if installed 3. System board 1. Video card, if installed 2. System board 1. Video card, if installed 2. System board 1. Run Setup 2. Video drivers update 3. Video card, if installed 4. System board 1. Video cable 2. Monitor 3. Video card, if installed 4. System board 1. Video card, if installed 2. System board 1. Video card, if installed 2. System board 1. Video card, if installed 2. System board 1. Video card, if installed 2. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 49 2. Re-run test 3. Replace the component called out in warning statement 4. Replace the component under test Chapter 7. Symptom-to-FRU Index 59